Due to COVID-19 shipping times may vary

Motion Detect Record Setting

Here is steps for setting Motion Detection Recording, after apply this setting, the DVR will not keep recording continueously.

 

Note:

  • This guide is only for our DVR, not for other brand DVR
  • Assume HDD is installed



Step 1:

  1. In DVR, right-click mouse -> Main Menu -> Alarm -> Motion Detect
  2. At Channel, choose which channel you need to record when motion is detected (example channel 1), then check Enable
  3. At Record Channel, click the corresponding channel (example channel 1)
  4. Click OK and back to Main menu


motion detcct



Step 2:

  1. Go to Main menu -> Record -> Record Plan
  2. At Channel, choose the channel just set in Motion Detect (example channel 1)
  3. At Length, default is 60 min, it means if motion is deteced, it will keep recording for 60 minutes, so you may need to revise it
  4. At Mode, check Schedule
  5. At Period, check Detect, uncheck Regular and Alarm
  6. Click OK back to Main menu, click OK again exit Main Menu

record plan



Step 3:

  1. When an object is moving in front of camera, at the bottom corner of channel screen (example channel 1), there is “leg” icon and “tape” icon, it means motion is detected and start recording.



Step 4:

  1. To view motion detected recording, right-click mouse -> Main menu -> Playback
  2. Choose the channel, click File List (two-arrow icon at the bottom right corner) to choose the recorded file with M mark

Leave a comment

Name .
.
Message .